RTE 64-66 Tach
kit
1964-1966 M1 Mopar
tachometer Repair Kit
Cost
$75
Detailed information
Your original 1964-66 Mopar tachometer has a paper printed circuit board inside
it. The original printed circuit board is by now around 40 years old, and many
of the electronic components on the board are likely to have degraded over
time. The new fiberglass printed circuit board that comes in our kit uses
modern integrated circuits that are more reliable and accurate than the
original parts. The original circuit board has an adjusting potentiometer that
is open to the environment, and these pots get noisy and corroded over time.
The new circuit board has high quality 15 turn adjustment potentiometers that
are sealed from the environment, so they should last many years with no
problem. Mopar used the same board for all the
tachometers in their cars from 1964 to 1966, so this tachometer kit is the one
you need for any car from that time
Once the tach
sending unit is removed from the car, it takes about 15 minutes to install the tach board. If you seem to have trouble with the can, you
could use the tach board without using the can. Since
each tachometer meter movement is slightly different, we suggest that you
calibrate the tach board using another RPM gauge so
that you will have an extremely accurate tachometer. For more information on
the installation, see the following links:
- Tach Kit Faq
- 64-66 Tachometer Installation Manual
- Mopar
Action Tachometer Kit Article
- Mopar
Collectors Guide Article
.